ACT-39 · Review of inter-vine bearing clearances.

Description

With the machine switched off and disconnected from the tractor, remove the plastic fairing from the probe from the inter-vine, then check by moving the stylus rod to ensure that the drive between the inner shaft and the outer shaft mounted by 2 studs is correctly produced. If there is slippage or relative movement between the two axles, replace and tighten the studs holding the inner shaft sequentially and progressively.

Compatible machine families

BIOCOMBICULTIFRUTDAVICULTORFRONT-XLID-FRONTID-NAMICID-WEEDERID-XLVENTRALX-TREME

Maintenance that uses this task

MaintenanceMachine families
MM-4 · Maintenance at 400 hours
AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release