ACT-104 · Review of inter-vine bearing clearances. (Replacement of grease

Description

With the machine turned off and disconnected from the tractor, verify that the tool is not resting on the ground, and taking the tool from its far end to the machine, try to move the interceplas manually from top to bottom and opening and closing it to verify that it is moving smoothly and there are no backs or clicks that could indicate that the bearings are damaged. If there is only some clearance, retighten the nuts on the two large interstock bushings as well as those on the tie rods and check that the clearances are removed. If the clearance does not disappear or is combined with clicking when moving the interstock, remove and replace the bearings.

Compatible machine families

Machine family compatibility has yet to be completed

Maintenance that uses this task

MaintenanceMachine families
MM-4 · Maintenance at 400 hours
AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release